1. Introduction
Lipolaser for fat reduction, use the soft laser to destroy the deep fat cells, broke the cell membrane, change the fat to triglyceride, then leave out the body, thanks to metabolism. The laser heat can Stimulate the subcutaneous dermal tissue collagen and elastic fibers hyperplasia, make the treated area skin tighten and elasticity.
Vacuum body reshaping handle piece and cavitation head can promote tissue metabolism, repel the cellulite, tighten the skin, strengthen the skin elasticity and so on. Its effect will last for a long time.
RF system uses 5MHz frequency, which can make cells produced a strong resonance of water molecules rotate and produce heat by the friction. Thereby heat up to the collagen and fat cells for the purpose of heating.
1. Introduction
Lipolaser for fat reduction, use the soft laser to destroy the deep fat cells, broke the cell membrane, change the fat to triglyceride, then leave out the body, thanks to metabolism. The laser heat can Stimulate the subcutaneous dermal tissue collagen and elastic fibers hyperplasia, make the treated area skin tighten and elasticity.
Vacuum body reshaping handle piece and cavitation head can promote tissue metabolism, repel the cellulite, tighten the skin, strengthen the skin elasticity and so on. Its effect will last for a long time.
RF system uses 5MHz frequency, which can make cells produced a strong resonance of water molecules rotate and produce heat by the friction. Thereby heat up to the collagen and fat cells for the purpose of heating.
5. Warranty
(1) Manufacturer warrants defects in materials and a period of 1 year for machine host, 3 months for the parts from the date of purchasing.
(2) Manufacturer won't bear any responsibility:
① Damage caused by accident, abuse, misuse or misapplication, it will be repaired with repair fee;
② Damage caused by service performed by anyone who is not technician or qualified by manufacturer;
③ Product or part that has been modified without any permission.
(3) Exclusion of liability:
① If fire, earthquake, war occurred;
② Operation mistakes;
③ Damage caused by using other method (not included in the use manual);
④ Do not make the machine close to the wall, keep certain spaces around from 30~35cm for air cooling;
⑤ Cleaning the device once a week minimally. Switch off the equipment and wipe the surface with a soft, wet tissue. Please take care and don’t pour any liquids to the equipment. Please clean the hand pieces after each treatment.
6. Parameters
Maximum Output Power | <150W |
Wave length | 660nm, 980nm |
Each Lamp Energy | 130 mW - 350mW |
Lamps Quantity | 104pcs |
Laser paddles | 6pcs (4 big pads and 2 small pads) |
Laser Source | Mitsubishi diode laser ML101J27 |
Vacuum Power | 100KPa |
RF Power | 1-50J/cm2 |
Cavitation | 35-40KHz |
Fuse | 5A |
Screen | 8' touch screen |
Cooling requirements | Air cooled |
Classification | Electrical Class 1, Type B applied part |
Safety | On Board Diagnostics |
Mode of Operation | IPXO |
Environmental requirements | 10°C to 40°C Non-condensing Humidities Below 75%RH |
Voltage | 220v or 110v/50Hz-60Hz |
Weight | 31KG |
Spec | 56cm*46cm*53cm |